Vorige onderwerp :: Volgende onderwerp |
Auteur |
Bericht |
tcdbv
|
Geplaatst: Di Jan 26, 2016 11:37 am Onderwerp: CDU's going to Standby mode |
|
|
Dear Sirs
I have full 737 home cockpit amd using Prosim since 2014. During 2 days my cdus do not work. When open the system I saw this messages in CDU scrren
"Test passed going to standby mode " and CDU closed
Could you please help me about this
Kindly regards
Erim
P.S: I did not do any update , My system is Win7 . FSX , Prosim |
|
Terug naar boven |
|
 |
Engravity_Support


|
Geplaatst: Wo Jan 27, 2016 12:29 am Onderwerp: |
|
|
When the cdu's V1 go into standby mode it means they receive no data from the software.
* Have you checked if cables/hubs are connected ?
* Has your prosim setup become corrupt. Please check if the correct commports are configured in prosim _________________ www.flyengravity.com
Build your own jetliner |
|
Terug naar boven |
|
 |
tcdbv
|
Geplaatst: Wo Jan 27, 2016 11:47 am Onderwerp: |
|
|
I changed cables and hub connections. But no change
I dont know correctly how to set up FMC in Prosim. Another person installed for me and I couldnt contact with him.. Could you please say to me where can I install the correct port from the prosim.
thx |
|
Terug naar boven |
|
 |
tcdbv
|
Geplaatst: Wo Jan 27, 2016 3:19 pm Onderwerp: |
|
|
Dear Sir,
I found it thank you for your help . I think COm port has been change. now working great . Thanks again. |
|
Terug naar boven |
|
 |
|